Refer to the exhibit. An engineer configured BGP between routers R1 and R3. The BGP peers cannot establish neighbor adjacency to be able to exchange routes. Which configuration resolves this issue?
A.
R1 router bgp 6501 address-family ipv6 neighbor AB01:2011:7:100::3 activate
B.
R3 router bgp 6502 address-family ipv6 neighbor AB01:2011:7:100::1 activate
C.
R1 router bgp 6501 neighbor AB01:2011:7:100::3 ebgp-multihop 255
D.
R3 router bgp 6502 neighbor AB01:2011:7:100::1 ebgp-multihop 255
B is the correct answer.
As it states in the debug "Connection refused by remote host".
Extra step needed on the remote router (R3) which is to activate the neighbor in address-family ipv6 unicast and run the "neighbor <neighbor_IP> activate" command.
The given answer is correct, because the pong show that the R3 responded, which meant the configuration is correct, then we must look at R1 to see what chase the issue
In the output you can see that R1 Neig session to R2 is active, but the R2 IP is rejection the connection, therefore you need to activate the neighbor connection on router 2
This section is not available anymore. Please use the main Exam Page.300-410 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
networkWiz
Highly Voted 2 years, 9 months ago[Removed]
Most Recent 10 months agoNhan
2 years, 8 months agoleogp79
2 years, 9 months agoReikidude00
2 years, 10 months agoReikidude00
2 years, 11 months agopiojo
2 years, 11 months agoIarn
3 years agoxziomal9
3 years ago