ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 350-801 All Questions

View all questions & answers for the 350-801 exam
Go to Exam

Exam 350-801 topic 1 question 79 discussion

Actual exam question from Cisco's 350-801
Question #: 79
Topic #: 1
[All 350-801 Questions]

A collaboration engineer troubleshoots issues with a Cisco IP Phone 7800 Series. The IPv4 address of the phone is reachable via ICMP and HTTP, and the phone is registered to Cisco UCM. However, the engineer cannot reach the CLI of the phone. Which two actions in Cisco UCM resolve the issue? (Choose two.)

  • A. Enable Settings Access under Product Specific Configuration Layout in Cisco UCM.
  • B. Enable FIPS Mode under Product Specific Configuration Layout in Cisco UCM.
  • C. Enable SSH Access under Product Specific Configuration Layout in Cisco UCM.
  • D. Set a username and password under Secure Shell Information in Cisco UCM.
  • E. Disable Web Access under Product Specific Configuration Layout in Cisco UCM.
Show Suggested Answer Hide Answer
Suggested Answer: CD 🗳️
by ciscogeek at May 7, 2022, 2:48 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
ciscogeek
Highly Voted 1 year, 1 month ago
Selected Answer: CD
Enable ssh for phone, and then setup username and password so that engineer can login to phone via CLI
upvoted 11 times
...
G0y0
Most Recent 4 months, 1 week ago
Selected Answer: CD
correct answers are C. and D. you set user and pass in ssh information and enable ssh acces. When you use putty, ingress the username and password you configured in ssh information in cucm, and the phone will be asking you again, a secound user and password. for 7800 phones, these credentialas are "debug" and "debug" for username and password, and you wil have gain access.
upvoted 1 times
...
DaKenjee
7 months, 1 week ago
Selected Answer: CD
had done this in past on 89xx/99xx only two settings necessary. On phone configuration page: (Answer C) Product Specific Configuration Layout > SSH Access= Enabled (Answer D) Secure Shell Information > Secure Shell User + Secure Shell Password
upvoted 3 times
...
usernamesarehard
10 months ago
Selected Answer: CD
Should be C & D
upvoted 1 times
...
laumail
12 months ago
Selected Answer: CD
SSH must be enabled and credentials has to be set
upvoted 3 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel