Exam 350-801 topic 1 question 261 discussion

Actual exam question from Cisco's 350-801

Question #: 261
Topic #: 1

An administrator is integrating a Cisco Unity Express module to a Cisco UCME system. A test call is placed to the Cisco Unity Express pilot number, but the administrator receives a busy signal. The dial-peer is configured as follows: dial-peer voice 4100 voip destination-pattern 41.. session protocol sipv2 session target ipv4:10.1.10.1 dtmf-relay sip-notify no vad
How is this issue resolved?

A. The dial-peer needs to be reconfigured to support the G.711 voice codec.
B. The destination pattern needs to be changed to match the dialed number of 4100.
C. The dial-peer needs to be reconfigured to support vad.
D. The dial-peer needs to be reconfigured to support H.323 instead of SIP.

Show Suggested Answer

Suggested Answer: A 🗳️

by Omitted at May 11, 2022, 3:32 a.m.

Comments

Submit Cancel

b3532e4

9 months, 1 week ago

Answer B

upvoted 1 times

b3532e4

9 months ago

Sorry , Cisco Unity Express 1.0 and 1.1 support mu-law only. A Is correct

upvoted 1 times

...

Omitted

3 years, 1 month ago

Selected Answer: A

From the below config guide. "A voice activity detection (VAD) must be switched off and a codec must be designated." https://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unity-express/62609-tdcmecue.html#anc17

upvoted 1 times

...