Within the vPC configuration of the 7K's the command peer-gateway is configured as confirmed with the command show vpc. what is the result of enabling this command?
A.
Enable 7K-3 to act as the active gateway for packet received on VLAN 101 that are addressed to the MAC address of 7K-4
B.
Enables 7K-4 to use of the vpc peer link for forwarding packets received on VLAN 100 that are addressed to the MAC address of 7K-3
C.
Generates IP redirect messages for packets switched though the peer-gateway router
D.
Cause the HSRP active router to update the ARP table on the standby router for faster convergence after the vPC peer link has flapped
E.
Allow the vpc peers to coordinate the LACP ID with must be the same on all links on the port channel.
Suggested Answer:D🗳️
The vPC peer gateway command allows either Nexus 7000 to intercept any packet (including HSRP packets) which is destined to the other peer's MAC address to prevent the packet from traversing the vPC peer link.
response should be A:
The vPC peer-gateway functionality allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
You must configure the peer-gateway functionality on both vPC peer switches.
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.300-165 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
solowolf12
5 years, 5 months agoCiscoTest
5 years, 7 months ago