ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 210-260 All Questions

View all questions & answers for the 210-260 exam
Go to Exam

Exam 210-260 topic 1 question 206 discussion

Actual exam question from Cisco's 210-260
Question #: 206
Topic #: 1
[All 210-260 Questions]

Which command do you enter to enable authentication for OSPF on an interface?

  • A. router(config-router)#area 0 authentication message-digest
  • B. router(config-router)#ip ospf authentication-key CISCOPASS
  • C. router(config-if)#ip ospf message-digest-key 1 md5 CISCOPASS
  • D. router(config-if)#ip ospf authentication message-digest
Show Suggested Answer Hide Answer
Suggested Answer: C 🗳️
by ciscotesting22 at March 31, 2019, 1:58 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Fabricio
5 years, 5 months ago
D is the correct answer
upvoted 1 times
...
jocarul
5 years, 6 months ago
"To enable" --> answer is D
upvoted 3 times
...
adil955
5 years, 7 months ago
R2(config)#interface fastEthernet 0/0 R2(config-if)#ip ospf message-digest-key 1 md5 MYPASS R2(config-if)#ip ospf authentication message-digest For MD5 authentication you need different commands. First use ip ospf message-digest-key X md5 to specify the key number and a password. It doesn’t matter which key number you choose but it has to be the same on both ends. To enable OSPF authentication you need to type in ip ospf authentication message-digest.
upvoted 2 times
...
ciscotesting22
6 years, 3 months ago
D answer is D
upvoted 3 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel