An IT administrator deployed an OEAP to the home of a remote user, but the OEAP cannot reach the WLC. Which two configuration settings must be completed before an OEAP is deployed successfully? (Choose two.)
A.
Configure Secondary Controller Name and Management IP address in the High Availability tab.
B.
Configure LSC to authorize the OEAP.
C.
Configure the AP mode to FlexConnect and check the box for Office Extend AP.
D.
Configure the WLC with an external IP address on the virtual interface.
E.
Configure Primary Controller Name and Management IP address in the High Availability tab.
C and E; see page 13, Step 4 and 5: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-1/configuration-guide/b_cg81/b_cg81_chapter_0101111.pdf
According to this https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/configuring_officeextend_access_points.html#ID2064 the provided answer is correct - C and E
C and E are the best answers:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/configuring_officeextend_access_points.html
Step 4 and 5 show that these are two of the valid steps required to configure the OEAP.
upvoted 3 times
...
This section is not available anymore. Please use the main Exam Page.300-430 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
somebodyfromtheinterwebz
2 years, 5 months agowirelessvibes
2 years, 8 months agocvndani
2 years, 9 months agocvndani
2 years, 9 months agocvndani
2 years, 9 months agoMcMurphy
7 months, 1 week agodaeman
2 years, 9 months ago