You are the wireless administrator for ACME corporation. You must configure a Cisco Catalyst 3850 Series Switch to work as mobility agent to allow access point association to this switch.
A.
Access point must be connected to an access port that has the access VLAN configured to be the same as the service port VLAN on the Catalyst 3850 switch.
B.
Access point must be connected to an access port with the access VLAN configured to be any VLAN that has a Layer 3 interface (SVI) on the Catalyst 3850 switch.
C.
Access point must be connected to an access port with the access VLAN configured to be the same as the wireless management VLAN on the Catalyst 3850 switch.
D.
Access point must be connected to an access port that has the access VLAN configured to be the same as the management VLAN for the switch stack.
E.
Access point must be connected to a trunk port with the native VLAN set to 1 in order to join the WLC on the Catalyst 3850 switch.
should be C:
Configure the AP discovery process.
In order for APs to join the controller, the switchport configuration must be set as an access port in the wireless management vlan:
If vlan 100 is used for the wireless management interface:
sw-3850-1(config)#interface gigabit1/0/10
sw-3850-1(config-if)#switchport mode access
sw-3850-1(config-if)#switchport access vlan 100
https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/116342-config-wlc-00.html#anc13
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.400-351 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
mrbott
5 years, 7 months ago