Exam 350-501 topic 1 question 281 discussion

Actual exam question from Cisco's 350-501

Question #: 281
Topic #: 1

Refer to the exhibit. A network engineer is configuring a new router for iBGP to improve the capacity of a growing network. The router must establish an iBGP peer relationship with its neighbor. The underlay network is already configured with the correct IP addresses. Which step should the engineer apply to complete this task?

A. Implement multicast routing on the router to support BGP hellos.
B. Configure the AS number for the router to share with its iBGP peers.
C. Configure the new router as an iBGP route reflector to support multiple iBGP peers.
D. Activate the BGP peers under the correct address family on the router.

Show Suggested Answer

Suggested Answer: D 🗳️

by oreluc at Sept. 16, 2022, 5:20 p.m.

Comments

Submit Cancel

oreluc

Highly Voted 2 years, 8 months ago

i go for D. You need to activate the bgp neighbors sessions!

upvoted 9 times

...

cipikacipiki

Highly Voted 2 years, 6 months ago

Selected Answer: D

if you see no bgp default ipv4-unicast, then you will need neighbor x.x.x.x activate under address-family

upvoted 9 times

...

TonBud

Most Recent 11 months ago

D for sure

upvoted 1 times

...

DUsoo

2 years, 2 months ago

Selected Answer: D

https://community.cisco.com/t5/switching/neighbor-activate-bgp/td-p/2445181

upvoted 1 times

...

Mo_El

2 years, 3 months ago

99% for C and 1% for D; the goal of this task is to install new router to support a growing network, this indicate this will be a route reflector. 1% for D since it's correct as well and needed any way for this task.

upvoted 2 times

thejag

2 years, 2 months ago

You don't necessarily need a route reflector as long if you have an iBGP full mesh.

upvoted 4 times

...