Exam 200-301 topic 1 question 486 discussion

Actual exam question from Cisco's 200-301

Question #: 486
Topic #: 1

Refer to the exhibit. An engineer is asked to configure router R1 so that it forms an OSPF single-area neighbor relationship with R2. Which command sequence must be implemented to configure the router?

A. router ospf 100 network 10.0.0.0 0.0.0.252 area0 network 10.0.1.0 0.0.0.255 area0
B. router ospf 100 network 10.0.0.0 0.0.0.3 area0 network 10.0.2.0 255.255.255.0 area0
C. router ospf 10 network 10.0.0.0 0.0.0.3 area0 network 10.0.1.0 0.0.0.255 area0
D. router ospf 10 network 10.0.0.0 0.0.0.3 area0 network 10.0.2.0 0.0.0.255 area0

Show Suggested Answer

Suggested Answer: C 🗳️

by alejandro12 at Nov. 20, 2022, 12:12 a.m.

Comments

Submit Cancel

Sdiego

Highly Voted 2 years, 1 month ago

Selected Answer: C

Forget about that comment, R1 advertises his networks, so C is correct.

upvoted 8 times

MinSun600

4 months, 1 week ago

now i understand what's going on

upvoted 1 times

...

FALARASTA

1 year, 9 months ago

I understand now about the second part. Thanks

upvoted 2 times

...

dsmitd33

Most Recent 4 months, 1 week ago

Selected Answer: C

none of these comments provide any clarity for the correct answer. if someone can help it would be greatly appreciated.

upvoted 1 times

...

Oden10

1 year, 4 months ago

Was this removed form the question :"R1 advertises his networks" ?

upvoted 1 times

...

Goena

2 years ago

Selected Answer: C

Answer C: Configure route to 10.0.0.0/30 with wildcard 0.0.0.3 Confugure route to 10.0.1.0/24 with wildcard 0.0.0.255 router ospf 10 network 10.0.0.0 0.0.0.3 area0 network 10.0.1.0 0.0.0.255 area0

upvoted 4 times

...