The Gig0/0 interface of two routers is directly connected with a 1G Ethernet link. Which configuration must be applied to the interface of both routers to establish an OSPF adjacency without maintaining a DR/BDR relationship?
A.
interface Gig0/0 ip ospf network non-broadcast
B.
interface Gig0/0 ip ospf network point-to-multipoint
C.
interface Gig0/0 ip ospf network point-to-point
cisco_R3#show run int e0/0.50
Building configuration...
Current configuration : 189 bytes
!
interface Ethernet0/0.50
encapsulation dot1Q 50
ip address 10.111.10.1 255.255.255.252
ip ospf network point-to-point <<<<<<<<<<<<<<<<<<<
ip ospf 1 area 22
bfd interval 999 min_rx 999 multiplier 3
end
cisco_R3#show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
192.168.255.2 1 FULL/DROTHER 00:00:33 192.168.255.2 Ethernet0/0.10
200.200.200.200 1 FULL/DR 00:00:34 192.168.255.22 Ethernet0/0.10
5.5.5.5 0 FULL/ - 00:00:34 10.111.10.2 Ethernet0/0.50 <<<<<<<<<<<<<<<<<
cisco_R3#
This section is not available anymore. Please use the main Exam Page.350-401 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
[Removed]
6 months, 2 weeks agodben
8 months, 3 weeks agonushadu
1 year, 11 months agoXerath
1 year, 11 months ago