ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 350-501 All Questions

View all questions & answers for the 350-501 exam
Go to Exam

Exam 350-501 topic 1 question 318 discussion

Actual exam question from Cisco's 350-501
Question #: 318
Topic #: 1
[All 350-501 Questions]





Refer to the exhibit. A NOC engineer is configuring label-based forwarding from CSR to the EPC gateway. Cell-site operation and maintenance for IPv4 traffic between 10.20.10.1 and 192.168.10.10 is already up. CR1 and CR2 are configured as route reflectors for AG1 and AG2. Which action completes the configuration?

  • A. Remove address-family labeled-unicast from the BGP session-group infra on AG1 for neighbor-group core.
  • B. Apply the BGP_Egress_Filter route policy to the BGP neighbor-group packet core on AG1.
  • C. Configure AG1 to allocate a label to the BGP routes that are received in the BGP session group transport.
  • D. Configure AG1 to allow the 300:100 and 200:100 communities in the BGP_Egress_Filter route policy.
Show Suggested Answer Hide Answer
Suggested Answer: B 🗳️
by Joejimikohn at Feb. 9, 2023, 7:01 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
sushil_bhattacharjee
7 months, 3 weeks ago
Selected Answer: B
ommunity-set Allowed-Comm 300:100, 200:100, !!BGP Packet Core Community=300:100 !!BGP Agg Community=200:100 route-policy BGP_Egress_Filter if community matches-any Allowed-Comm then pass neighbor-group Packet-Core use session-group infra address-family ipv4 labeled-unicast route-reflector-client next-hop-self route-policy BGP_Egress_Filter both Answer: B
upvoted 2 times
...
sushil_bhattacharjee
7 months, 3 weeks ago
community-set Allowed-Comm 300:100, 200:100, !!BGP Packet Core Community=300:100 !!BGP Agg Community=200:100 route-policy BGP_Egress_Filter if community matches-any Allowed-Comm then pass neighbor-group Packet-Core use session-group infra address-family ipv4 labeled-unicast route-reflector-client next-hop-self route-policy BGP_Egress_Filter both Answer: B
upvoted 1 times
...
thejag
1 year, 4 months ago
Selected Answer: B
B looks good
upvoted 1 times
...
Joejimikohn
1 year, 8 months ago
Selected Answer: C
I think C is correct
upvoted 2 times
Joejimikohn
1 year, 8 months ago
I was wrong B is correct.
upvoted 3 times
cocopost
7 months ago
Why not C? Usually when we have BGP labeled unicast as we do here, we need the allocate-label command to ensure IPv4 prefixes are sent as BGP-LU not just BGP.
upvoted 1 times
...
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago