Exam 200-301 topic 1 question 1053 discussion

Actual exam question from Cisco's 200-301

Question #: 1053
Topic #: 1

Refer to the exhibit. A network engineer is adding another physical interface as a new member to the existing Port-Channel1 bundle. Which command set must be configured on the new interface to complete the process?

A. no switchport
channel group 1 mode active
B. no switchport
channel-group 1 mode on
C. switchport mode trunk
channel-group 1 mode active
D. switchport
switchport mode trunk

Show Suggested Answer

Suggested Answer: A 🗳️

by j1mlawton at Feb. 16, 2023, 11:26 a.m.

Comments

Submit Cancel

sdmejia01

Highly Voted 1 year, 10 months ago

The configuration shows is a layer 3 port channel, hence you need to use the command no switchport.

upvoted 16 times

...

gewe

Highly Voted 1 year, 10 months ago

its layer 3

upvoted 7 times

...

[Removed]

Most Recent 8 months, 2 weeks ago

Selected Answer: A

A is correct

upvoted 2 times

...

Bhrino

1 year, 7 months ago

Selected Answer: A

because it says"R" we know its a layer three port channel meaning we need the no swtchport command and this is a Lacp so it would us active / passive

upvoted 4 times

...

j1mlawton

1 year, 10 months ago

Why not C?

upvoted 1 times

oatmealturkey

1 year, 10 months ago

(RU) means Layer 3 & in use, so need to make it a layer 3 interface which is done with "no switchport"

upvoted 9 times

tumajay

8 months ago

what will be the letter if it was layer 2?

upvoted 1 times

masala94

4 months, 3 weeks ago

You have it in Flag table (SU)

upvoted 1 times

...