Exam 1Y0-240 topic 1 question 33 discussion

Actual exam question from Citrix's 1Y0-240

Question #: 33
Topic #: 1

Which two options should a Citrix Administrator consider when adding a secondary device in a high availability (HA) pair? (Choose two.)

A. Configure the HA status of the Primary Node as STAYPRIMARY.
B. HA Monitoring should be disabled on all the unused interfaces.
C. Both the devices should have different SNIP addresses.
D. The nsroot password should be the same on both nodes.
E. The Independent Network Configuration (INC) mode should be enabled.

Show Suggested Answer

Suggested Answer: AE 🗳️

by Dszi67 at Aug. 22, 2019, 7:10 p.m.

Comments

Submit Cancel

gerrboy

3 years, 6 months ago

A B is correct. The primary should stay primary while configuring the HA to ensure secondary is not overwriting the config once it joined the HA pair. Turn off HA Monitor interface/channels that are down checkbox for fast and reliable transition of NS from secondary to primary. You only select INC when joining two NS with unlike subnet.

upvoted 2 times

...

Calyfas

4 years, 5 months ago

B and D are correct. “Run the following command on both primary and secondary NetScaler appliance to disable any network interface that is not connected to the network:” “Note: The NetScaler nsroot password must also be the same on each node. The RpcNode password does not have to be the same as the nsroot password.” https://support.citrix.com/article/CTX116748

upvoted 1 times

...

GTJ

5 years ago

AB is correct. @Broom - RPC password must be the same, not NSROOT

upvoted 4 times

...

Brum

5 years, 1 month ago

nsroot password must be the same as well !!

upvoted 1 times

...

Dszi67

5 years, 8 months ago

Correct: A,B