Exam SK0-005 topic 1 question 372 discussion

Actual exam question from CompTIA's SK0-005

Question #: 372
Topic #: 1

After a technician upgrades the firmware on a database server that is connected to two external storage arrays, the server prompts the technician to configure RAID. The technician knows the server had several configured RAID sets and thinks the firmware upgrade cleared the RAID configurations. Which of the following should the technician do to troubleshoot this issue?

A. Power cycle the storage arrays and rescan RAID on the server.
B. Boot the OS into recovery mode and rescan the disks.
C. Restore the default RAID configuration and reboot.
D. Perform a rescan on the server's RAID controller.

Show Suggested Answer

Suggested Answer: D 🗳️

by msspeedy at April 21, 2025, 11:03 a.m.

Comments

Submit Cancel

Aleksandre

2 weeks ago

Selected Answer: D

D - Given answer is correct.

upvoted 1 times

...

msspeedy

2 weeks, 3 days ago

Selected Answer: A

A. Power Cycle and Rescan: Shut down the server completely. Disconnect the power cords from the server and storage arrays. Wait a few minutes, then reconnect the power cords and power up the server. During startup, enter the RAID controller's setup utility (usually by pressing a key like Ctrl+I or F2 during boot) and attempt to rescan the RAID arrays.

upvoted 1 times

Aleksandre

2 weeks ago

D - Just go for the rescan, disconnecting power cords does nothing.

upvoted 1 times

...

Exam SK0-005 All Questions

View all questions & answers for the SK0-005 exam

Exam SK0-005 topic 1 question 372 discussion

Comments

Aleksandre

msspeedy

Aleksandre

SY0-701