The lspci command can display the following information about the system hardware:
A. Device IRQ settings
D. Device vendor identification
E. Ethernet MAC address
The lspci command is used to display information about the PCI buses and devices present in a system. It can show information about device IRQ settings, device vendor identification, and Ethernet MAC addresses, among other things. The lspci command does not display information about the system battery type or PCI bus speed.
ABD
-00:15.1 PCI bridge: VMware PCI Express Root Port (rev 01)
-Interrupt: pin A routed to IRQ 16
-00:07.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01) (prog-if 8a [ISA Compatibility mode controller, supports both channels switched to PCI native mode, supports bus mastering])
upvoted 1 times
...
This section is not available anymore. Please use the main Exam Page.LX0-103 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
linux_admin
2 years, 2 months agoant_man
3 years, 7 months ago