Exam NSE7_SDW-7.0 topic 1 question 1 discussion

A. diagnose sys sdwan intf-sla-log Page 95 of study guide

sla-log Show details of health-check quality information in last 10 minutes intf-sla-log Show details of interface quality information.

A. diagnose sys sdwan intf-sla-log

A. diagnose sys sdwan intf-sla-log

diag sys sdwan sla-log is used to display member metrics diag sys sdwan intf-sla-log is used to display member utilization

Answer is A: A. diagnose sys sdwan intf-sla-log. The answer is on page 321 SD-WAN 7.2 Study Guide.

A. diagnose sys sdwan intf-sla-log. The answers is in the pag 321 SD-WAN Study Guide. D. diagnose sys sdwan sla-log is only for view the member metrics

A. diagnose sys sdwan intf-sla-log. The answers is in the pag 321 SD-WAN Study Guide. D. diagnose sys sdwan sla-log is only for view the member metrics

A. page 29 of 7.2 study guide - Member Utilization: dia sys sdwan intf-sla-log <INT>

Just read the quetion carefully and look at the output of both commands. A is obviously correct as there is no "utilization statistics" in D

are these questions still valid i want to book an appointment for my exam. Can anyone confirm? Thanks in advance

The correct answer is D. SD-WAN 7.2 Study Guide page 321 You can view the stored member metrics by running the diagnose sys sdwan sla-log command. Note that you must include the name of the performance SLA followed by the member configuration index number. To display the SLA logs per interface, you run the diagnose sys sdwan intf-sla-log command.

A. diagnose sys sdwan intf-sla-log Page 95 of study guide 7.0 > utilization statistic D is only for performance statistics

None of these questions are on the 7.0 test. I failed today.

You can see it by entering this command in cli mode "diagnose sys sdwan ?" the return of this command show us the definition of each of them.

None of these questions are on the 7.0 test

This is a tricky one, just read again the question and then the guide: You can view the stored member metrics by running the diagnose sys sdwan sla-log command. Note that you must indicate the name of the performance SLA followed by the member configuration index number. To display the stored member utilization, you run the diagnose sys sdwan intf-sla-log command.