Exam NSE7_EFW-7.2 topic 1 question 72 discussion

Actual exam question from Fortinet's NSE7_EFW-7.2

Question #: 72
Topic #: 1

Refer to the exhibit, which shows an ADVPN network.

ADVPN Network topology -

An administrator must configure an ADVPN using IBGP and EBGP to connect overlay network 1 with 2.

What must the administrator configure in the phase 1 VPN IPSEC configuration of the Hub2Hub tunnels?

A. set auto-discovery-receiver enable
B. set auto-discovery-sender enable
C. set auto-discovery-forwarder enable
D. set add-route enable

Show Suggested Answer

Suggested Answer: C 🗳️

by 924114f at Feb. 18, 2025, 12:32 a.m.

Comments

Submit Cancel

4302201

4 months ago

Selected Answer: C

7.2 Study Guide page 332

upvoted 1 times

...

modaba

4 months ago

Selected Answer: C

Answer is C, Here we have a configuration with two hubs, p332 a- on the spokes b sends the information to the spokes c yes send the information between the hubs about the spokes d another command witch is used for add a static route into a routing table

upvoted 2 times

...

Alexander101

4 months ago

Selected Answer: C

Hub to hub must be set to forwarder.

upvoted 2 times

...

5652d21

4 months, 1 week ago

Selected Answer: C

Page 336 of Study Guide. A - no - set auto-discovery-receiver enable - only on spokes B - yes - set auto-discovery-sender enable - Page 332 "from both hubs (phase 1)" C - yes - set auto-discovery-forwarder enable - Page 332 "must be enabled on the Hub to Hub tunnel (phase 1)" D - no - set add-route must be disabled to ensure dynamic routing is used. If this is a "pick one" then it is most likely C. If it is "pick 2" then it is C and B.

upvoted 2 times

...