ExamTopics Logo
Mail Us[email protected]
Menu
Fortinet Discussions
exam questions

Exam NSE8_810 All Questions

View all questions & answers for the NSE8_810 exam
Go to Exam

Exam NSE8_810 topic 1 question 29 discussion

Actual exam question from Fortinet's NSE8_810
Question #: 29
Topic #: 1
[All NSE8_810 Questions]

You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active "" Passive FortinControllers. Both
FortiControllers have the configuration shown below, with the rest of the configuration set to the default values:

Ñonfig system ha -
set mode dual
set password fortinetnse8
set group-id 5
set chassis-id 1
set minimize-chassis-failover enable
set hbdev "b1"
end
Both FortiControllers show Master status. What is the problem in this scenario?

  • A. The management interface of both FortiControllers was connected on the same work.
  • B. The priority should be set higher for FortiController on slot-1.
  • C. The b1 interface of the two FortiControllers do not see each other.
  • D. The chassis ID settings on FortiController on slot 2 should be set to 2.
Show Suggested Answer Hide Answer
Suggested Answer: CB 🗳️
by xilosapo at April 4, 2025, 6:18 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Currently there are no comments in this discussion, be the first to comment!
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel