Exam NSE4_FGT-6.4 topic 1 question 95 discussion

B & C is correct. FortiGate_Infrastructure_6.4 page 417-418 - memory used 90% ->conserved mode

Fortigate Infrastructure 7.0 pg 367-368

Found here, https://community.fortinet.com/t5/FortiGate/Technical-Tip-Conserve-mode-changes/ta-p/198502 configurable thresholds Though it is recommended to keep the default memory threshold, a new CLI command has been added to allow administrators to adjust the thresholds. Default values are : - red : 88% of total memory is considered "used memory" - extreme : 95% of total memory is considered "used memory" - green : 82% of total memory is considered "used memory"

I have just changed it on the Fortinet training lab firewall: Local-FortiGate (global) # show full-configuration | grep memory set memory-use-threshold-extreme 97 set memory-use-threshold-green 83 set memory-use-threshold-red 89 set wad-memory-change-granularity 10

B e C são verdadeiras

upsolotetely BC

phototrait right

B&C :FG Infra 7.0 page 383: Not accept config changes, does not run quarantine action - forwarding files to SandBox.

I am not sure why you said B is correct because I was looking and I just found options C&D are correct... if there is any document to prove I can't make a change into conserve mode I want to read it...regards https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/921599/diagnostics

B & C are correct. page 417-

B and C is correct. No Doubt.

B & C is correct. No Doubt.

D is also correct, once in Conserve Mode you can only access the FG via the console port.

B & C is correct answer