Exam NSE4_FGT-6.0 topic 1 question 97 discussion

A and D I think - 10.10.3.2 doesn't even exist on the diagram

I did the exam today. This question came with following correct way C. 172.20.2.0/24 (1/150) via 10.10.1.2, port1 [10/0] D. 172.20.2.0/24 (1/150) via 10.30.3.2, port3 [10/0] Therefore the correct answers are C & D

A & D. A = It's the only option with 10.10.1.2 via port1. Diagram clearly shows is one of 2 paths. D = While both C&D seem to be correct, C is wrong because 10.10.3.2 is not on the topology. B = Wrong for 2 reasons (1) administrative distance is highest...(2)10.10.3.2 is also not in the topology. A & D are correct.

ECMP must meet the requirements to be considered: Destination Subnet, Distance, Metric & Priority. It should be C and D, because they have the same distance and priority, maybe it was misspelled, from the port and the IP address.

b y c pero esta mal escrito la respuesta

Answer is C&d

C & D correct for routes to be considered for ECMP must have the same destination subnet, Distance, metric and priority, the question has typos. but c&d are most practical FortiGate Infrastructure6.2 study guide pg.29

the answers have alot of typos or idk. C and D go out port 3 with an IP that doesnt even exist.

A & D only possible answers as them refer to the exiting IPs on the diagram

B and D are correct. FortiGate_Security_6.2_Study_Guide-Online (page 276) It says: "On the GUI, upload options include Real Time, Every Minute, and Every 5 Minutes (Default). If your FortiGate model includes an internal hard drive, you also have the store-and-upload option. This allows you to store logs to disk and then upload to FortiAnalyzer or FortiManager at a scheduled time (usually a low bandwidth time). You can configure the store-and-upload option, as well as a schedule, on the CLI only. "

The correct is A&D because it has the same AD, correct interface and next-hop.

Look at next hop. A and D

A and D

For me , A and D are more relevant answers

i think A & B

C & D are correct, but in C you need to chance the next hop

C answer is invalid as the IP address does not exist on whole diagram. A&D looks more precise.