ExamTopics Logo
Mail Us[email protected]
Menu
Hp Discussions
exam questions

Exam HP0-Y50 All Questions

View all questions & answers for the HP0-Y50 exam
Go to Exam

Exam HP0-Y50 topic 1 question 119 discussion

Actual exam question from HP's HP0-Y50
Question #: 119
Topic #: 1
[All HP0-Y50 Questions]

Refer to the exhibit.

All switch interfaces shown in the exhibit have these characteristics:

Are configured in routed-mode -

Have IP addresses -
Run Open Shortest Path First (OSPF)
Network architect wants to ensure that routing switch 1 uses the faster link in preference to the slower link, which should be used in failover situations. Which step should be architect perform to meet this requirement?

  • A. Disable ECMP on Routing switch 1 and on other routing switches for consistency.
  • B. Set the designated router preference on Routing switch 2 interface Forty1/0/48 to a lower level than on Routing switch 3 interface Ten1/0/1:1.
  • C. Set the OSPR reference bandwidth on the routing switches to an appropriate level, such as 100000 Mbps.
  • D. Configure Routing switch 1 interface Ten1/0/1:1 as a silent, or a passive, OSPF interface.
Show Suggested Answer Hide Answer
Suggested Answer: D 🗳️
by bikelepo at April 4, 2025, 6:36 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
f2792c0
2 days, 22 hours ago
Selected Answer: D
This one
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel