ExamTopics Logo
Mail Us[email protected]
Menu
Juniper Discussions
exam questions

Exam JN0-351 All Questions

View all questions & answers for the JN0-351 exam
Go to Exam

Exam JN0-351 topic 1 question 21 discussion

Actual exam question from Juniper's JN0-351
Question #: 21
Topic #: 1
[All JN0-351 Questions]

You need to configure a LAG between your switches.
In this scenario, which two statements are correct? (Choose two.)

  • A. Duplex and speed settings are not required to match on both participating devices.
  • B. Duplex and speed settings are required to match on both participating devices.
  • C. Member links are not required to be contiguous ports.
  • D. Member links are required to be contiguous ports.
Show Suggested Answer Hide Answer
Suggested Answer: BC 🗳️
by julin_10 at Dec. 14, 2023, 1:49 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
TheRich2812
1 month, 2 weeks ago
Selected Answer: BC
B and C are correct
upvoted 1 times
...
sandaruwann654
8 months, 2 weeks ago
B,C are correct
upvoted 1 times
...
kopcink
1 year ago
Selected Answer: BC
BC are correct
upvoted 1 times
...
julin_10
1 year, 1 month ago
Selected Answer: BC
Up to 64 Ethernet interfaces can be grouped to form a LAG, and In a Junos Fusion, up to 1,000 LAGs are supported on QFX10002 switches acting as aggregation devices. The LAG must be configured on both sides of the link. The interfaces on either side of the link must be set to the same speed and be in full-duplex mode.
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel