ExamTopics Logo
Mail Us[email protected]
Menu
Juniper Discussions
exam questions

Exam JN0-664 All Questions

View all questions & answers for the JN0-664 exam
Go to Exam

Exam JN0-664 topic 1 question 71 discussion

Actual exam question from Juniper's JN0-664
Question #: 71
Topic #: 1
[All JN0-664 Questions]

Click the Exhibit button.



Referring to the exhibit, you are receiving the 192.168.0.0/16 route on both R3 and R4 from your EBGP neighbor. You must ensure that R1 and R2 receive both BGP routes from the route reflector.

In this scenario, which BGP feature should you configure to accomplish this behavior?

  • A. add-path
  • B. route-target
  • C. multipath
  • D. multihop
Show Suggested Answer Hide Answer
Suggested Answer: A 🗳️
by antigel8 at April 11, 2024, 9:27 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
141f14b
10 months ago
Selected Answer: A
requirement is that R1,R2 receive both routes (no LB mentioned) by default, the RR will perform best-path selection and will send only one route to R1,R2. So we need add-path on route-reflector A - correct answer
upvoted 4 times
...
dhikra
1 year ago
i think answer C not A : because A allow add path addtional
upvoted 2 times
...
dhikra
1 year ago
answer C
upvoted 1 times
...
antigel8
1 year ago
A. Enable advertisement and/or reception of multiple paths to a destination to/from the same BGP peer, instead of advertising/receiving only the active path to/from the same BGP peer.
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel
exam
Someone Bought Contributor Access for:
SY0-701
London, 1 minute ago