Exam AZ-800 topic 4 question 36 discussion

Actual exam question from Microsoft's AZ-800

Question #: 36
Topic #: 4

HOTSPOT
-

Your network contains an Active Directory Domain Services (AD DS) forest. The forest contains the sites and site links shown in the following exhibit.

The sites contain the bridgehead domain controllers shown in the following table.

The IP intersite transport container is configured as shown in the following exhibit.

For each of the following statements, select Yes if the statement is true. Otherwise, select No.

NOTE: Each correct selection is worth one point.

Show Suggested Answer

Suggested Answer:

by GeorgiAngelov at April 30, 2024, 3:49 p.m.

Comments

Submit Cancel

NoMedi

6 months, 2 weeks ago

N-N-N "DC1 can replicate directly to DC3": No Why: While "Bridge all site links" does allow transitive replication between sites connected by site links, it doesn't create direct physical connections. Instead, it allows replication to flow through intermediate sites along the existing site links. "DC3 will load balance replication traffic to DC1 via SiteLink1 and SiteLink4": No Why: For load balancing to occur between site links, the costs must be equal "To ensure that replication between DC4 and DC2 is routed via DC1, the configuration of the IP inter-site transport container must be modified": No Why: With "Bridge all site links" enabled, the system automatically uses the least cost path Traffic will naturally route through DC1 due to lower cost, no modification needed

upvoted 4 times

jpcapobianco

5 months, 1 week ago

1. Can DC1 replicate directly to DC3? Answer: No 2. Does automatic load balancing occur between alternative replication paths? Answer: No 3. To ensure replication between DC4 and DC2 is routed through DC1, does the configuration of the IP Intersite Transport Container need to be modified? Answer: No

upvoted 1 times

...

Ksk08

9 months, 3 weeks ago

"DC1 can replicate directly to DC3": There is no direct site link from Site1 to Site3. Replication would need to go through Site2. Therefore, this statement is No. "DC3 will load balance replication traffic to DC1 via SiteLink1 and SiteLink4": Since there is no direct path from DC3 to DC1, and load balancing requires multiple paths with similar costs, this statement is No. "To ensure that replication between DC4 and DC2 is routed via DC1, the configuration of the IP inter-site transport container must be modified": To route replication specifically through DC1, you would need to adjust site link costs or configurations. This statement is likely Yes.

upvoted 1 times

...

JimmyC

1 year, 1 month ago

"Bridge all site links" will automatically create replication connections between all sites that can communicate with an existing chain of site links. Thus A is Yes, and C is No.

upvoted 3 times

jpcapobianco

5 months, 1 week ago

Can DC1 replicate directly to DC3? Answer: No Explanation: There is no direct site link between Site1 (where DC1 is located) and Site3 (where DC3 is located). However, with "Bridge All Site Links" enabled (default configuration), replication can still occur indirectly via Site2 as the intermediate site. The logical replication path would be Site1 → Site2 → Site3.

upvoted 1 times

...

SIAMIANJI

1 year, 3 months ago

The answer is Y N N

upvoted 3 times

...

GeorgiAngelov

1 year, 3 months ago

I think that it should be: Y Y N

upvoted 1 times

...