Exam MB-320 topic 2 question 31 discussion

Actual exam question from Microsoft's MB-320

Question #: 31
Topic #: 2

You work for a gem wholesaler that sells raw diamonds. Diamonds are purchased and sold in individual boxes but weighed and inventoried in carats.
You are setting up a catch weight item for diamonds. Each box of diamonds must be tracked by its individual container weight.
You need to set up this item as a full visibility catch weight item.
Which two steps must you perform? Each correct answer presents part of the solution.
NOTE: Each correct selection is worth one point.

A. Assign it a Serial number group with defined as 1. per qty.
B. Assign the item a Tracking dimension group with active serial number control.
C. Create an inter-class unit of measure conversion between boxes and carats.
D. Assign a Tracking dimension group with batch number as the only active tracking dimension.

Show Suggested Answer

Suggested Answer: BC 🗳️
References:
https://docs.microsoft.com/en-us/dynamicsax-2012/appuser-itpro/create-a-catch-weight-item-with-full-visibility

by BaDkO at March 21, 2021, 2:20 a.m.

Comments

Submit Cancel

Daichisan

3 years, 7 months ago

BC should be correct

upvoted 1 times

...

BaDkO

4 years, 2 months ago

"To designate a catch weight item as full visibility, you must specify a tracking dimension group for the item where the Serial number dimension is set to active with Serial number control." Source: https://docs.microsoft.com/en-us/dynamicsax-2012/appuser-itpro/about-catch-weight-items#set-up-catch-weight-items

upvoted 2 times

...

BaDkO

4 years, 2 months ago

If option A actually means "serial number control" is active in the Tracking dimension group, then I believe the correct answers are A and B.

upvoted 3 times

viking1

3 years, 10 months ago

However, assigning a serial number group is not enough in itself. Serial number tracking must be enabled through the tracking dimension group, so BC should still be correct.

upvoted 3 times

...