Exam AZ-600 topic 7 question 1 discussion

Actual exam question from Microsoft's AZ-600

Question #: 1
Topic #: 8

You remove all the workloads from the int1 region and change the registration model to capacity.
You prepare additional Azure AD tenants for each partner.
You need to configure multitenancy.
Which two actions should you perform for each guest tenant? Each correct answer presents part of the solution.
NOTE: Each correct selection is worth one point.

A. Run the Register-AzSWithMyDirectoryTenant cmdlet and specify https://management.int1. northwind.com as the endpoint.
B. Run the Register-AzSGuestDirectoryTenant cmdlet and specify https://management.int1. northwind.com as the endpoint.
C. Run the Register-AzSGuestDirectoryTenant cmdlet and specify https://adminmanagement.int1. northwind.com as the endpoint.
D. Change the registration model to pay-as-you-use.
E. Run the Register-AzSWithMyDirectoryTenant cmdlet and specify https://adminmanagement.int1. northwind.com as the endpoint.

Show Suggested Answer

Suggested Answer: AC 🗳️

by AWSChia at July 23, 2021, 6:14 p.m.

Comments

Submit Cancel

Eltooth

Highly Voted 3 years, 4 months ago

Selected Answer: AC

Correct - C then A

upvoted 6 times

...

TonytheTiger

Most Recent 2 years, 11 months ago

On the exam (06/24/2022), different format but not part of a case study

upvoted 1 times

...

d0bermannn

3 years, 7 months ago

correct, steps: C ,then A

upvoted 2 times

...

AWSChia

3 years, 10 months ago

Correct answer. Below is the right link to use to validate the answer: https://docs.microsoft.com/en-us/azure-stack/operator/enable-multitenancy?view=azs-2008&pivots=management-tool-powershell

upvoted 3 times

...