You need to configure the app to meet the address verification requirements. Which two actions should you perform? Each correct answer presents part of the solution. NOTE: Each correct selection is worth one point.
A.
Make the address fields read-only after they have been verified.
B.
Open a confirmation dialog when the command bar button is selected.
C.
Enable the command bar button only when the address shows as not verified.
D.
Clear the field indicating the address is valid when an address field changes.
Address requirement:
> The system must perform address validation any time an address is added or updated in the model-driven app user interface.
> Validation must not be performed unless an address is changed.
> Users must initiate address validation by selecting a button on the command bar.
> The user must re-enter the address information to trigger validation.
From those, we can get 2 points:
1.) Address can be changed after it's verified.
2.) Ability to run validation can be disabled if there are no changes to the address.
So C&D.
I had this case on my exam on 27/10/2022. I don't remember if this specific question was asked.
upvoted 2 times
...
This section is not available anymore. Please use the main Exam Page.PL-400 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
Kepty
Highly Voted 8 months, 3 weeks agonorthstar88
Highly Voted 8 months, 3 weeks agoJuan0414
Most Recent 2 months, 4 weeks agoTheExamMaster2020
7 months ago