Welcome to ExamTopics
ExamTopics Logo
- Expert Verified, Online, Free.
Mail Us [email protected]
Menu
sale

Want to Unlock All Questions for this Exam?

Full Exam Access, Discussions, No Robots Checks

27
Students signed up in the last 24H

Juniper JN0-663 Exam Actual Questions

The questions for JN0-663 were last updated on April 15, 2024.
  • Viewing page 1 out of 24 pages.
  • Viewing questions 1-4 out of 96 questions
 

Topic 1 - Single Topic

Question #1 Topic 1


You notice an inconsistency between the routing table and the OSPF database, as shown in the exhibit.
What are two reasons for this behavior? (Choose two.)

  • A. The LSA is a Type 4 LSA.
  • B. An OSPF export policy is being applied to the route.
  • C. An OSPF import policy is being applied to the route.
  • D. The LSA is a Type 5 LSA.
Reveal Solution Hide Solution   Discussion   16

Correct Answer: BC 🗳️

Question #2 Topic 1


R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)

  • A. Apply the prepend policy as an import policy under group R1.
  • B. Configure multipath under the global BGP configuration.
  • C. Configure multipath under group R1.
  • D. Apply the prepend policy as an import policy under group R3.
Reveal Solution Hide Solution   Discussion   7

Correct Answer: AB 🗳️

Question #3 Topic 1


Referring to the exhibit, hosts in Site 1 and Site 2 are unable to communicate with each other through the Layer 3 VPN.
What is the problem?

  • A. The two sites are in the same AS.
  • B. The two sites are using the same instance type.
  • C. The two sites are using the same route target.
  • D. The two sites are using the same route distinguisher.
Reveal Solution Hide Solution   Discussion   6

Correct Answer: A 🗳️

Question #4 Topic 1


You manage an MX Series device which includes the configuration shown in the exhibit. Traffic marked with DSCP 000011 is entering the ge-1/0/4 interface at
102 Mbps. The traffic exits the device on the ge-1/0/5 interface. No other traffic is transiting the router.
In this scenario, what happens to traffic exceeding 100 Mbps?

  • A. Traffic exceeding 100 Mbps is redirected to a rate limiter.
  • B. Traffic exceeding 100 Mbps is buffered.
  • C. Traffic exceeding 100 Mbps is dropped.
  • D. Traffic exceeding 100 Mbps is forwarded.
Reveal Solution Hide Solution   Discussion   6

Correct Answer: C 🗳️

Next Questions

Get IT Certification

Unlock free, top-quality video courses on ExamTopics with a simple registration. Elevate your learning journey with our expertly curated content. Register now to access a diverse range of educational resources designed for your success. Start learning today with ExamTopics!

Start Learning for free
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel