Exam 350-601 topic 1 question 485 discussion

Actual exam question from Cisco's 350-601

Question #: 485
Topic #: 1

Refer to the exhibit. An engineer must configure FCoE with these requirements:
• VLAN 100 must be used to carry the Ethernet traffic.
• Fabric A must use FCoE on VLAN 11 and VSAN 11.
• Fabric B must use FCoE on VLAN 12 and VSAN 12.
• vfc 10 on Fabric A must be bound to Ethernet 1/1 on N5K_1.
• vfc 11 on Fabric B must be bound to Ethernet 1/1 on N5K_2.

Which interface vfc 10 configuration accomplishes these requirements?

Show Suggested Answer

Suggested Answer: B 🗳️

by luisam at Feb. 14, 2024, 1:30 a.m.

Comments

Submit Cancel

Mr_Myself

1 year ago

Selected Answer: B

Vlan 100 is not a vsan, so answer B

upvoted 3 times

...

asd248402

1 year, 3 months ago

Selected Answer: B

B is right ad mode need to be E for connecting another switch

upvoted 1 times

...

udo2020

1 year, 4 months ago

I think it should be C! In fabric port (F port) mode, an interface functions as a fabric port. This port can be connected to a peripheral device (host or disk) operating as an N port. An F port can be attached to only one N port. With B an E Port is to connect to another E Port.

upvoted 1 times

...

crooks_1988

1 year, 5 months ago

Either B or C. From different Cisco docs: vFC interfaces always operate in trunk mode; vFC interfaces do not operate in any other mode. You can configure allowed VSANs on a vFC by using the switchport trunk allowed vsan command under the vfc interface (which is similar toFC TFand TE ports) VSAN trunking is supported on native Fibre Channel interfaces, but not on virtual Fibre Channel interfaces

upvoted 1 times

...

luisam

1 year, 5 months ago

Answer B

upvoted 2 times

...