Suggested Answer:Explanation🗳️
To configure the aging time for all MAC addresses, perform this task:
Command Purpose - Step 1 switch# configure ter- Enters configuration mode. minal Step 2 switch(config)# mac-ad- Specifies the time before an entry ages out and is dis- dress-table aging-time carded from the MAC address table. The range is from seconds [vlan vlan_id] 0 to 1000000; the default is 300 seconds. Entering the value 0 disables the MAC aging. If a VLAN is not specified, the aging specification applies to all VLANs. Reference: http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/configuration/guide/cli/M ACAddress.html
This section is not available anymore. Please use the main Exam Page.300-115 Exam Questions
Log in to ExamTopics
Sign in:
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.
Upvoting a comment with a selected answer will also increase the vote count towards that answer by one.
So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
aadeeb
5 years, 11 months ago