Exam 350-601 topic 1 question 297 discussion

Actual exam question from Cisco's 350-601

Question #: 297
Topic #: 1

A Cisco Nexus 7000 Series switch runs VXLAN, and interface Ethernet 7/30 is configured as a trunk port. Which command set configures the switch to act as a gateway for VLAN 50? interface Ethernet7/30 no switchport no shutdown service instance 1 vni no shutdown encapsulation profile VSI_50_TO_500 default

A. encapsulation profile vni VSI_50_TO_500 dot1q 50 vni 500 bridge-domain 50 member vni 500 interface Bdi50 ip address 10.50.50.51/24
B. encapsulation profile vni VSI_50_TO_500 dot1q 500 vni 50 bridge-domain 500 member vni 50 interface Bdi500 ip address 10.50.50.51/24
C. encapsulation profile vni VSI_50_TO_500 dot1q 500 vni 50 bridge-domain 500 member vni 50 interface Vlan500 ip address 10.50.50.51/24
D. encapsulation profile vni VSI_50_TO_500 dot1q 50 vni 500 bridge-domain 50 member vni 500 interface Vlan50 ip address 10.50.50.51/24

Show Suggested Answer

Suggested Answer: A 🗳️

by 7korn7 at Sept. 23, 2022, 3:20 p.m.

Comments

Submit Cancel

GuyThatTakesDumps

7 months, 3 weeks ago

Selected Answer: A

A is ok!

upvoted 3 times

...

7korn7

8 months ago

Selected Answer: A

The internal interface on the VTEP is configured as a layer-3 port. However, there is no IP assigned to it. It is also important to note that the BD value defined on the VTEP does not have to match the VLAN ID on the device from which you are sending the traffic. However, the dot1q to VNI mapping defined in the encapsulation profile, which is called under the service instance on the internal interface, must match the VLAN ID on the device from which you are sending the traffic. https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/vxlan/config/cisco_nexus7000_vxlan_config_guide_8x/configuring-vxlan-flood-and-learn.html#:~:text=and%20Learn%20Configuration-,Example%20of%20VXLAN%20Flood%20and%20Learn%20Configuration,-The%20following%20example

upvoted 4 times

...