ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 300-115 All Questions

View all questions & answers for the 300-115 exam
Go to Exam

Exam 300-115 topic 5 question 33 discussion

Actual exam question from Cisco's 300-115
Question #: 33
Topic #: 5
[All 300-115 Questions]

Which of the following commands configures a port with a VLAN?

  • A. vlan
  • B. vlan database
  • C. switchport access vlan
  • D. switchport mode access C
Show Suggested Answer Hide Answer
Suggested Answer: Explanation 🗳️
The switchport access vlan command configures a port with a virtual local area network (VLAN). The syntax for the switchport access vlan command is as follows: switchport access vlan {vlan-id | dynamic}
If the vlan-id parameter is specified, then a static VLAN will be configured. If the dynamic keyword is specified, then dynamic VLAN assignment by a VLAN
Membership Policy Server (VMPS) will occur. Static VLAN configuration is easy to configure, secure and works well in networks where moves, additions, and changes are rare. In environments where this not the case, dynamic VLANs may be preferable.
The vlan command is used to add VLANs to the VLAN database and to configure VLAN settings.
The vlan database command is issued to enter VLAN configuration mode. The following commands can be issued from VLAN configuration mode: abort - exits without applying changes apply - applies changes and bumps the revision number exit - applies changes, bumps the revision number and exits VLAN configuration mode no - negates a command reset - discards changes and rereads the VLAN database show - displays information vlan - configures the VLAN database vtp - configures VLAN Trunking Protocol (VTP) settings
The switchport mode access command disables trunking for a port. The syntax for the switchport mode command is as follows: switchport mode {access | trunk | dynamicdesirable | dynamicauto}
Objective:

Layer 2 Technologies -
Sub-Objective:

Configure and verify VLANs -
References:
Cisco > Cisco IOS Interface and Hardware Component Command Reference > squelch through system jumbomtu > switchport access
by Bab500bab500 at Nov. 20, 2019, 4:24 a.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Bab500bab500
5 years, 7 months ago
Which of the following commands configures a port with a VLAN? A. vlan B. vlan database C. switchport access vlan D. switchport mode access Answer C
upvoted 1 times
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel