ExamTopics Logo
Mail Us[email protected]
Menu
Cisco Discussions
exam questions

Exam 350-601 All Questions

View all questions & answers for the 350-601 exam
Go to Exam

Exam 350-601 topic 1 question 348 discussion

Actual exam question from Cisco's 350-601
Question #: 348
Topic #: 1
[All 350-601 Questions]





Refer to the exhibit. An engineer must set access to Cisco IMC. The access must be allowed by logging onto the https://datacenter.local web page. The configuration presented is on the Cisco UCS C240 Series Server.

Which set of commands completes the configuration?

  • A.
  • B.
  • C.
  • D.
Show Suggested Answer Hide Answer
Suggested Answer: D 🗳️
by JGBARRIO at Feb. 8, 2023, 4:57 p.m.

Comments

Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.
Switch to a voting comment New
Submit Cancel
Manu_75
2 months, 2 weeks ago
Selected Answer: D
Key clues in exhibit are: - DHCP enable = yes / so it's already enabled and CIMC already obtained an IPv4 addr - Obtain DNS from DHCP = no / so we need to configure it manually - VLAN enable =yes / so the interface is a dot1q trunk and we need to set the VLAN to 10
upvoted 2 times
...
CoAsT_x
7 months, 1 week ago
Selected Answer: D
Agree the VLAN needs to be set. Also, the other ones that have dhcp-enabled and then static IP addresses doesn't add up to me. I will go with D.
upvoted 1 times
...
SysAd
10 months, 1 week ago
should be C, VLAN 1 is default VLAN or comparable to untagged.
upvoted 1 times
...
Huberttheman
1 year, 5 months ago
Bad question, if only we had the switch port configuration. We need to set the DNS server so it is either C&D
upvoted 1 times
...
Scheldon
1 year, 8 months ago
Selected Answer: D
D. In C we have enabling that CIMC will use DHCP but there is no DHCP server in topology. Beside that we are configuring the things which are configured. Server configuration is showing that VLAN is in use and it is set to VLAN1, hence we need to change it to VLAN 10 + add DNS server IP
upvoted 2 times
...
paradigm88
1 year, 8 months ago
D looks correct to me because dhcp is disabled and is configuring correct dns server manually
upvoted 3 times
...
vladdar
1 year, 9 months ago
I think correct answer is D. We need to set vlan 10. https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/sw/cli/config/guide/b_Cisco_CIMC_CLI_Configuration_Guide.pdf
upvoted 2 times
...
Rocky_Truth
1 year, 9 months ago
Selected Answer: C
C is correct
upvoted 1 times
...
JGBARRIO
1 year, 10 months ago
It´s the B
upvoted 1 times
JGBARRIO
1 year, 10 months ago
Sorry! It´s the C
upvoted 1 times
...
...
Community vote distribution
A (35%)
C (25%)
B (20%)
Other
Most Voted
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.

SaveCancel