Exam 350-601 topic 1 question 332 discussion

Actual exam question from Cisco's 350-601

Question #: 332
Topic #: 1

Refer to the exhibit. A network administrator experiences these issues with the network:
• PC1 is experiencing a buffering problem for video applications.
• The servers that are connected to SW2 are experiencing packet drops when they connect to the Internet.

The engineer wants to configure the required traffic capture to investigate the issue further.

Which configuration must be implemented to monitor the traffic?

A. N9K(config)# monitor session 5 tx
N9K(config-monitor)# description Span_session_5
N9K(config-monitor)# source vlan 10-15 rx
N9K(config-monitor)# source interface ethernet 1/2
N9K(config-monitor)# destination interface ethernet 2/3
B. N9K(config)# monitor session 5 rx
N9K(config)# monitor session 5 tx
N9K(config-monitor)# description Span_session_5
N9K(config-monitor)# source interface ethernet 1/1
N9K(config-monitor)# source interface ethernet 1/2
N9K(config-monitor)# destination interface ethernet 2/3
C. N9K(config)# monitor session 5 tx
N9K(config-monitor)# description Span_session_5
N9K(config-monitor)# source interface ethernet 1/1
N9K (config-monitor)# source interface ethernet 1/2
N9K(config-monitor)# destination interface ethernet 2/3
D. N9K(config)# monitor session 5 rx
N9K(config-monitor)# description Span_session_5
N9K(config-monitor)# source vlan 10 rx
N9K(config-monitor)# source interface ethernet 1/2
N9K(config-monitor)# destination interface ethernet 2/3

Show Suggested Answer

Suggested Answer: D 🗳️

by 7korn7 at Feb. 17, 2023, 2:54 p.m.

Comments

Submit Cancel

Scheldon

Highly Voted 2 years ago

Selected Answer: D

All answer would allow to for traffic monitoring to check what is the issue. But per task we should monitor only PC1 (VLan10) and both servers connected via switch on Eth1/2. Based on that I think that correct answer is D D. N9K(config)# monitor session 5 rx N9K(config-monitor)# description Span_session_5 N9K(config-monitor)# source vlan 10 rx N9K(config-monitor)# source interface ethernet 1/2 N9K(config-monitor)# destination interface ethernet 2/3

upvoted 5 times

...

Mustafa

Most Recent 10 months ago

Selected Answer: D

D is the most convenient answer.

upvoted 1 times

...

GoForCCNP

1 year ago

Selected Answer: B

It should be B or C, because SW2 have vlans 18-23 and the servers connected to it are with problems too, so you can't use just vlan 10 as source. I would say rx for PC1 and tx for servers, so B is the one.

upvoted 2 times

...

Winnah

2 years, 1 month ago

Has to be D. In order to get only PC1 from eth1/1, use source as VXLAN 10

upvoted 4 times

...

7korn7

2 years, 2 months ago

source interface ethernet 1/1 - will monitor both PCs, however from question only PC1 has problem. i couldn't find the correct answer